Note that when viewing the engine hours, the hourglass icon (shown below) will appear in the bottom-right-hand corner of the display. When the hourglass icon and the wrench icon are both illuminated, this indicates you are viewing the service hours. Then press and hold the UP or DOWN button. To reset the trip meters, toggle to the meter you want to reset. Press and hold the UP or DOWN button to reset the trip timer. TT will display when the trip timer is shown on the gauge. Toggle the Up/Down buttons to change the information displayed in Area 2. Pressing the MODE button will change the information displayed in Area 1. For more on the speed limiter, see below. On models equipped with a low speed limiter, indicator light will remain on when low speed limiter is active. This lamp illuminates when the headlamp switch is set to high beam. The lamp is a reminder to wear helmet and seat belt (if equipped) before operating. This lamp flashes for several seconds when the key is turned to the ON position. This lamp illuminates when the transmission is in neutral and the ignition key is in the ON position. If the indicator flashes, a severe overheating condition exists. This lamp illuminates to indicate an overheated engine. EPS operation is possible with key on/engine off for up to 5 minutes. Your authorized Polaris Dealer can assist. Illuminates when a fault has occurred in the EPS system. Do not operate the vehicle if this warning appears. This indicator appears if an EFI-related fault occurs.
On the AWD Indicator (7), segments of the indicator illuminate based on the drive mode that's engaged. See below for more information on setting the time. The Clock (6) displays time in a 12-hour or 24-hour format. For more information, see the Periodic Maintenance Chart section of your Owner's Manual. Your Polaris Dealer can provide scheduled maintenance.
On the Service Indicator (5), a flashing wrench symbol alerts the operator that the preset service interval has been reached and your vehicle is due for scheduled maintenance. All segments, including the fuel icon, will flash. When the last segment clears, a low fuel warning is activated. The Fuel Gauge (4) shows the level of fuel in the fuel tank. - = Gear Signal Error (or shifter is between gears)ĭisplay Area 2 (2) displays the odometer, trip meter, trip meter 2, trip timer, voltage, engine temperature, engine hour meter, programmable service hour interval, ground speed or engine RPM.ĭisplay Area 1 (3) displays engine RPM, ground speed or coolant temperature.The Gear Indicator (1) displays gear shifter position. Immediately clean off any gasoline that splashes on the instrument cluster.įor more information on cleaning your Polaris Off-Road Vehicle, listen to the Cleaning: It's Not Just About Looking Good episode of the Polaris Podcast. Do not allow insect sprays to contact the lens. Do not use alcohol to clean the instrument cluster. Wash the vehicle by hand or with a garden hose, using mild soap. Note that the use of a high pressure washer may damage the instrument cluster. Some features are not applicable to all models. The following is a look at the features and functions of the digital instrument cluster on your Polaris RANGER, ACE, Sportsman or Scrambler.